Correlation between thermal annealing temperature and Joule-heating based insulator-metal transition in VO2 nanobeams

Rapid thermal annealing of VO2 nanobeams in an ambient argon environment has been carried out at various temperatures after device fabrication. Our analysis revealed that increasing the annealing temperature from 200??C to 400??C results in the reduction of both ohmic and nanobeam resistances with an appreciable decrease in joule-heating based transition voltage and transition temperature, while samples annealed at 500??C exhibited a conducting rutile-phase like characteristics at room temperature. In addition, these variation trends were explored using a physical model and the results were found to be in agreement with the observed results, thus verifying the model.open2

Low Frequency and Variability of FLT3 Mutations in Korean Patients with Acute Myeloid Leukemia

FLT3 mutations are common genetic changes, and are reported to have prognostic significance in acute myeloid leukemia (AML). The FLT3 internal tandem duplication (ITD) and the D835 activating mutation in the tyrosine kinase domain (TKD) were analyzed by polymerase chain reaction (PCR) in the genomic DNA of Korean patients with AML at diagnosis and during follow-up. There were 226 patients with AML enrolled between March 1996 and August 2005. The incidence of ITD and TKD at diagnosis was 13% (29/226) and 3% (6/226). When compared to Western and other Asian patients with AML, Korean patients had a lower frequency by about two-thirds of ITD and TKD. Among the non-M3 cases (N=203), the patients with an ITD had a significantly shorter event-free survival when compared with those without an ITD (p=0.0079). Among 54 relapsed patients, 9 patients had the FLT3 ITD at diagnosis. Six patients demonstrated a reappearance of the ITD and 3 patients remained negative at relapse. One patient, among 45 patients who relapsed, had a negative baseline ITD but acquired a de novo ITD at relapse. There were 101 samples from 93 patients in remission; they were all negative for an ITD. Among 34 patients who failed to achieve a remission, five patients had a persistent ITD and one patient had a de novo ITD. These results support the concept of resistance of FLT3 ITD leukemic clones to chemotherapy. Therefore, effective therapy with FLT3 targeting agents may improve the prognosis of non-M3 AML patients with the FLT3 mutation

Clinical Benefit of Low Molecular Weight Heparin for ST-segment Elevation Myocardial Infarction Patients Undergoing Primary Percutaneous Coronary Intervention with Glycoprotein IIb/IIIa Inhibitor

The efficacy of low molecular weight heparin (LMWH) with low dose unfractionated heparin (UFH) during percutaneous coronary intervention (PCI) with or without glycoprotein (Gp) IIb/IIIa inhibitor compared to UFH with or without Gp IIb/IIIa inhibitor has not been elucidated. Between October 2005 and July 2007, 2,535 patients with ST elevation acute myocardial infarction (STEMI) undergoing PCI in the Korean Acute Myocardial Infarction Registry (KAMIR) were assigned to either of two groups: a group with Gp IIb/IIIa inhibitor (n=476) or a group without Gp IIb/IIIa inhibitor (n=2,059). These groups were further subdivided according to the use of LMWH with low dose UFH (n=219) or UFH alone (n=257). The primary end points were cardiac death or myocardial infarction during the 30 days after the registration. The primary end point occurred in 4.1% (9/219) of patients managed with LMWH during PCI and Gp IIb/IIIa inhibitor and 10.8% (28/257) of patients managed with UFH and Gp IIb/IIIa inhibitor (odds ratio [OR], 0.290; 95% confidence interval [CI], 0.132-0.634; P=0.006). Thrombolysis In Myocardial Infarction (TIMI) with major bleeding was observed in LMHW and UFH with Gp IIb/IIIa inhibitor (1/219 [0.5%] vs 1/257 [0.4%], P=1.00). For patients with STEMI managed with a primary PCI and Gp IIb/IIIa inhibitor, LMWH is more beneficial than UFH

Virtual reality-based monitoring test for MCI: A multicenter feasibility study

ObjectivesAs the significance of the early diagnosis of mild cognitive impairment (MCI) has emerged, it is necessary to develop corresponding screening tools with high ecological validity and feasible biomarkers. Virtual reality (VR)-based cognitive assessment program, which is close to the daily life of the older adults, can be suitable screening tools for MCI with ecological validity and accessibility. Meanwhile, dehydroepiandrosterone (DHEA) has been observed at a low concentration in the older adults with dementia or cognitive decline, indicating its potential as a biomarker of MCI. This study aimed to determine the efficacy and usability of a VR cognitive assessment program and salivary DHEA for screening MCI.MethodsThe VR cognitive assessment program and the traditional Montreal Cognitive Assessment (MOCA) test were performed on 12 patients with MCI and 108 healthy older adults. The VR program operates in a situation of caring for a grandchild, and evaluates the memory, attention, visuospatial, and executive functions. An analysis of covariance (ANCOVA), a partial correlation analysis, and receiving operating characteristic (ROC) curve analysis were conducted for statistical analysis.ResultsAccording to the ANCOVA, no significant difference in MOCA scores was found between the normal and MCI groups (F = 2.36, p = 0.127). However, the VR total score of the MCI group was significantly lower than that of the normal group (F = 8.674, p = 0.004). There was a significant correlation between the MOCA and VR scores in the total and matched subdomain scores. The ROC curve analysis also showed a larger area under the curve (AUC) for the VR test (0.765) than for the MOCA test (0.598), and the sensitivity and specificity of the VR program were 0.833 and 0.722, respectively. Salivary DHEA was correlated with VR total (R2 = 0.082, p = 0.01) and attention scores (R2 = 0.086, p = 0.009).ConclusionThe VR cognitive test was as effective as the traditional MOCA test in the MCI classification and safe enough for older adults to perform, indicating its potential as a diagnostic tool. It has also been shown that salivary DHEA can be used as a biomarker for MCI

SHIELDING ANALYSIS OF DUAL PURPOSE CASKS FOR SPENT NUCLEAR FUEL UNDER NORMAL STORAGE CONDITIONS

Korea expects a shortage in storage capacity for spent fuels at reactor sites. Therefore, a need for more metal and/or concrete casks for storage systems is anticipated for either the reactor site or away from the reactor for interim storage. For the purpose of interim storage and transportation, a dual purpose metal cask that can load 21 spent fuel assemblies is being developed by Korea Radioactive Waste Management Corporation (KRMC) in Korea. At first the gamma and neutron flux for the design basis fuel were determined assuming in-core environment (the temperature, pressure, etc. of the moderator, boron, cladding, UO2 pellets) in which the design basis fuel is loaded, as input data. The evaluation simulated burnup up to 45,000 MWD/MTU and decay during ten years of cooling using the SAS2H/OGIGEN-S module of the SCALE5.1 system. The results from the source term evaluation were used as input data for the final shielding evaluation utilizing the MCNP Code, which yielded the effective dose rate. The design of the cask is based on the safety requirements for normal storage conditions under 10 CFR Part 72. A radiation shielding analysis of the metal storage cask optimized for loading 21 design basis fuels was performed for two cases; one for a single cask and the other for a 2×10 cask array. For the single cask, dose rates at the external surface of the metal cask, 1m and 2m away from the cask surface, were evaluated. For the 2×10 cask array, dose rates at the center point of the array and at the center of the casks’ height were evaluated. The results of the shielding analysis for the single cask show that dose rates were considerably higher at the lower side (from the bottom of the cask to the bottom of the neutron shielding) of the cask, at over 2mSv/hr at the external surface of the cask. However, this is not considered to be a significant issue since additional shielding will be installed at the storage facility. The shielding analysis results for the 2×10 cask array showed exponential decrease with distance off the sources. The controlled area boundary was calculated to be approximately 280m from the array, with a dose rate of 25mrem/yr. Actual dose rates within the controlled area boundary will be lower than 25mrem/yr, due to the decay of radioactivity of spent fuel in storage

Unravelling the switching mechanisms in electric field induced insulator-metal transitions in VO2 nanobeams

We studied insulator-metal transitions in VO2 nanobeams for both abrupt and gradual changes in applied electric fields. Based on the observations, the Poole-Frenkel effect explained the abrupt transition, while the gradual case is found to be dominated by the Joule heating phenomenon. We also carried out power model and finite element method based simulations which supported the Joule heating phenomena for gradual transition. An in-principle demonstration of the Poole-Frenkel effect, performed using a square voltage pulse of 1 ?? s duration, further confirms the proposed insulator-metal transition mechanism with a switching time in the order of 100 ns. Finally, conductivity variations introduced via rapid thermal annealing at various temperatures validate the roles of both Joule heating and Poole-Frenkel mechanisms in the transitions.close0

Postfabrication Annealing Effects on Insulator–Metal Transitions in VO₂ Thin-Film Devices

In order to investigate the metal–insulator transition characteristics of VO₂ devices annealed in reducing atmosphere after device fabrication at various temperature, electrical, chemical, and thermal characteristics are measured and analyzed. It is found that the sheet resistance and the insulator–metal transition point, induced by both voltage and thermal, decrease when the devices are annealed from 200 to 500 °C. The V 2p_3/2 peak variation in X-ray photoelectron spectroscopy (XPS) characterization verifies the reduction of thin-films. A decrease of the transition temperature from voltage hysteresis measurements further endorse the reducing effects of the annealing on VO₂ thin-film

Effects of point defect healing on phosphorus implanted germanium n+/p junction and its thermal stability

In this work, the effect of Ge point defect healing process between 550 °C and 650 °C is investigated, in the aspect of leakage (off) current and junction depth of Ge n+/p junction diodes using ECV, TEM, J-V, and SIMS analyses. After 600 °C anneal, off-current density (2 × 10−4 A/cm2) is dramatically reduced due to the defect healing phenomenon that decreases the number of point defects, subsequently providing a higher on/off-current ratio of 5 × 103. In spite of the high healing temperature, junction diodes seem not to suffer from the deep diffusion of phosphorus (P) in Ge because those diffuse mostly through VGe. In addition, it is also confirmed that Ti is an appropriate material in terms of diffusion barrier and diffusivity for Ge n+/p junction contact metal.Published versio

Colloidal Synthesis of SnSe Nanocolumns through Tin Precursor Chemistry and Their Optoelectrical Properties

Through tin precursor chemistry, SnSe nanocrystals were phase-selectively prepared. Monomeric N-heterocyclic stannylene, [Me₂Si­(N^tBu)₂Sn:], having lone pair electrons, was prepared by a literature method, and it had a direct reactivity toward selenium powder. The resultant dimerized compound with a 1:1 stoichiometric ratio of Sn to Se was used as a precursor to synthesize tin selenides. Thermolysis of the precursor solution in oleylamine resulted in SnSe plates. The oriented attachment of SnSe plates through (100) crystalline planes formed the SnSe nanocolumns, which were characterized by SEM, TEM, PXRD, EDS, and XPS. The indirect band gap of the SnSe nanocolumns was red-shifted, compared with those of SnSe plates. The SnSe nanocolumns showed an increased photocurrent under visible light irradiation. We believe that similar precursor chemistry in this work can be further extended to group IVA elements